All our products are treated with Woodoc Transit Stabiliser and we suggest using Woodoc 30 or Silkwood after installation and maintaining with Woodoc Penetrating Weatherproof Wax or Silkwood.
Other products are usually compatible with the stabiliser, but check with your paint stockist. The prime object is to protect during building.
If a paint finish is required please inform us as we increase our tolerance between sash and frame to allow for four coats of paint.
When glazing, it is essential to use sealer or putty on the inside of the glass up against the rebate. Sashes and fittings are designed for 3mm to 4mm glass. Small pane windows and doors are supplied without glazing beads.
All windows viewed from the outside - sashes open outward and all windows are fitted with solid brass handles.
ALSO AVAILABLE:
Special Joinery
Glazing: Done according to building regulations and with beading.
Pivot Doors
- Doors are to be stacked flat on a 100% level surface in a dry well ventilated area not exposed to sun or heat from sheds or containers, to avoid warping caused by change in temperature and humidity.
- Doors are to be treated preferably with the following products: Woodoc or Silkwood on all six sides. Doors must be sealed at all exposed surfaces caused by installation the same day of installation.
- All doors supplied by Fair Deal Wooden Windows are only temporarily treated, and it is preferred that the doors be treated on the same day that delivery takes place.
- Warping from and up to 6mm on the concave face of the door when measured with a straight edge, will not be considered as defective and will not be replaced by the manufacturer.
- Doors will not be exchanged if the above mentioned procedures have not been complied with.
- Do not order doors for installment until concrete floors and plaster walls are finished and completely dry.
- Always handle doors with care to avoid scratching and other damage.
- The swelling or shrinking of doors is a natural occurrence in timber and not a fault in the construction of the door.
- Do not trim more than 30mm from the height of the door. Trim up to 10mm from the top of the door and up to 20mm from the bottom. Doors with 190mm kick rail may have up to 30mm trimmed from the bottom. Do not trim more than 10mm in width, reduced equally from both sides.
